Adhesive Tapes - 6022 PVC Premium Electrical Adhesive Tape 0.15mm - PR International Ltd

6022 PVC Premium Electrical Adhesive Tape 0.15mm

6022 is a 0.15mm premium quality, electrical self-extinguishing soft PVC tape which uses an aggressive pressure senstive rubber- based adhesive system. It has been designed for use where a recognised specification or international standard is required and where environmental safety is a concern.

APPLICATIONS

Primary electrical insulation

Harnessing

Protection for low and medium voltage cable splices

Colour coding

Industrial applications

Used for electrical cables wrapping in automotive application

Hand application

PRODUCT BENEFITS

Excellent resistance to abrasion, corrosion and moisture

Tape can be applied at low temperature (till -10 °C)

IMQ and VDE Approval Certificates according to IEC 60454-3-1

Provides higher voltage breakdo-down and mechanical protection that 2702

Index temperature 0 °C to +90 °C

High dielectric strength and good mechanical protection

Excellent conformability

Environmentally friendly technology

Conforms to BS3924

Conforms to European Directive 2011/65 (RoHS 2) and Commission Delegated Directive (EU)2015/863 (RoHS 3)

TECHNICAL PROPERTIES Unit	Nominal Value
Thickness mm	0.15
Tensile Strength N/cm	30
Elongation at Break %	170
Adhesion to Steel N/cm	1.8
Adhesion to Backing N/cm	1.8
Dielectric Strength KV/mm	40
Flammability ---	Self extinguishing

STANDARD PRESENTATION

Roll length : 10, 20, 25 and 33 metres

Roll width : 15, 19 and 25mm

Core : 32 mm Scapa branded cardboard core

Packaging : Cellowrapped with Scapa label and bar code

Colours : Black, White, Grey, Red, Blue, Yellow, Dark green, Light Green, Brown, Orange, Violet, Yellow/green

RECOMMENDATIONS

Rolls should be stored flat on their cut edges in the original packaging. The product must be protected from dust, heat, moisture, direct sunlight and solvent fumes. The storage temperature should be between +5°c and +25°c. Use within 24 months of receipt.

The tape should be applied with sufficient tension to ensure an optimum bonding and a minimum of two layers with a half overlap. The final layer should be wrapped with a lower tension to prevent flagging effects.

Surfaces should be clean, dry and free of dust, grease, oil or other contaminants.